Just taking in what i have to do to the hull mold to get it ready to build a boat out of. things like, drain the water, some light sanding, an over all buffing, and then 8 coats of mold release.. To build one fiberglass boat, it is often said, you must in fact build two boats: the finished product and the mold from which it springs. with a female mold, you normally build three boats to get one--first a male plug on which the female mold is formed, then the mold, and finally the boat itself.. Work the fiberglass cloth into the freshly applied epoxy with the putty knife. use scissors to trim any excess fiberglass cloth. allow the epoxy/fiberglass to cure completely. sand the fiberglass with your palm sander and 120-grit sandpaper to smooth out any high spots..
No comments:
Post a Comment